Attic wet after rain? Here’s what to do.

You climb into the attic after a Burlington storm and spot a dark, damp patch on the plywood. You don't know if it's an old stain or a new problem. Water could be sneaking in somewhere uphill from that mark.

A wet attic after heavy rain usually means water is getting past your roof's outer layer. The dark spot you see is where the water drips down, not where it enters. The real hole is often higher up on the roof. Missing shingles, cracked flashing around a vent, or a dried-out rubber boot on a pipe can let rain in. On a sloped roof, water runs downhill along the plywood before it soaks through. That stain might be 10 feet from the actual leak.

Fixing this starts with finding the source. A small flashing repair might cost a few hundred dollars. Replacing a section of rotted decking and shingles can run higher. If the leak has been active for months, you may need to replace insulation or treat mold. The size of the damaged area and how long the water has been sitting both affect the final bill. A quick inspection gives you real numbers, not guesses.

Mark the wet area with painter's tape. Check the roof above it for curled or missing shingles. Look at the rubber boot around plumbing pipes. Do not just paint over the stain. Trapped moisture rots the wood and invites mold. Call TruRoof for a free inspection. We trace the water path with photos and give you a written estimate so you know exactly what needs fixing.

After the repair, your attic stays dry in the next downpour. No more panic when clouds roll in. The decking is solid, the insulation is dry, and you stop worrying about what might be growing up there. A fixed roof means one less thing on your mind every time it rains in Boone County.

What people in Burlington say

Other things people in Burlington ask